Kinematic Calibration of an Industrial Manipulator without External Measurement Devices

摘要

This paper presents a practical approach to fully automated kinematic calibration of an industrial manipulator. The approach is based on the principle of plane constraint. The electrical signal is used to fix the moment of contact between the conductive tool and the flat surface. The measurement data are manipulator configurations (joint angles) at the moment of contact. A modification of the algorithm to deal with the scaling problem is also proposed. This approach provides both high calibration accuracy and lower cost of the experimental setup compared to coordinate measuring machines (CMMs), laser trackers, and vision systems. The article examines the impact of various methods of kinematic parameterization of manipulators: the Denavit – Hartenberg agreement (DH), product of exponentials (POE), as well as the complete and parametrically continuous model (CPC) on the calibration accuracy. A comparison is made of the open-loop and the proposed closed-loop calibration methods on the Puma 560 model known in the literature. POE parameters were converted to DH and CPC to compare accuracy after calibration based on these parameterizations. The method of computing POE-CPC transformation as a solution to a certain optimization problem is proposed. The problem of identifying geometric parameters in the presence of restrictions is solved by gradient optimization methods. Experiments have been carried out on an ABB IRB 1600 industrial manipulator with an installed conductive probe and an ABB IRBP A-500 robotic positioner with a conductive metal flat surface. A technique for indirectly checking the accuracy of calibration of kinematic parameters is proposed based on a study of the accuracy of manipulation when using these parameters.