Fabrication of thin-walled hat-shaped beams from ultrahigh strength steel by laser-assisted robotic roller forming

摘要

Laser-assisted robotic roller forming (LRRF) can be applied to forming ultrahigh strength sheets to products with high geometrical accuracy. In this study, the geometrical profiles and three-point bending performance of thin-walled hat-shaped beams formed by LRRF and robotic roller forming (RRF, i.e., without laser heating) were experimentally investigated. It is found that the geometrical distortion resulted from the accumulation of longitudinal tension during multi-pass roller forming is significantly alleviated by LRRF. In addition, the bending performance of LRRF beam assembly is ameliorated at the initial deformation stage of three-point bending. The improvement is ascribed to a smaller bending radius and the alter of mechanical properties at the laser heat-affected zone. The lower geometrical precision of beams formed without laser heating results in early failure of spot welds of the beam assembly during three-point bending. LRRF beam assembly exhibits larger displacements at failure, and the failure mode is cracking at the edge of the laser-irradiated region. The pronounced microstructure differences on both sides of the crack suggest that the obvious laser-induced mechanical property gradients are responsible for the failure of LRRF beam assembly during three-point bending.