Temperature rise in the pulp chamber induced by a conventional halogen light-curing source and a plasma arc lamp.

摘要

PURPOSE: To assess and compare the pulp chamber temperature increase during resin-based composite polymerization with two different light-curing units. METHODS: A Class I cavity was prepared in an extracted lower molar under standardized conditions using a specially designed industrial robot system. The dentin layer between the pulp chamber and the floor of the cavity was 1 mm thick. Pulp chamber temperature rises (starting temperature: 20.0 +/- 0.1 degrees C) were recorded for four different series of investigations using both the halogen curing lamp Elipar Visio (light-curing: 40 s) and the plasma arc lamp Apollo 95E (light-curing: 3 seconds): Group A: Operation of the light-curing units directly over the untreated, empty cavity; Group B: Resin-based composite polymerization without previously applied cement base or bonding agent; Group C: Resin-based composite polymerization with a previously applied cement base; Group D: Resin-based composite polymerization with a previously applied bonding agent. In each of the four groups 10 measurements were carried out for every light-curing unit. Data were statistically analyzed using ANOVA, post-hoc Scheffé test and t-test. RESULTS: The lowest temperature increase (0.3 degrees C) was recorded during composite polymerization with a previously applied cement base using the Apollo 95E unit (Group C, P < 0.05). The highest temperature increase was induced when using the Elipar Visio unit directly over the untreated cavity (Group A, P < 0.05). In Groups A, C and D higher pulp chamber temperature measurements were obtained when using the Elipar Visio unit as compared to the Apollo 95E plasma arc lamp (P < 0.01). In Group B, no significant differences were recorded during the composite polymerization when using the two different light-curing units (P > 0.05).